Rubber Cutting
From rubber gaskets to shoe soles, our laser cutter can precisely cut rubber for any purpose you may have for it.
We know rubber, and can make the most accurate cuts by taking into account the expansion and reduction of each type of rubber as it heats and cools.
We can cut:
Almost any kind rubber.
Hard rubber up to half an inch thick.
Thin rubber such as neoprene up to an inch thick.
As thin as you want, we can make paper thin cuts if required.
FAQ
As deep as you want, we have very powerful flying gantry machines that can make deep burn relatively fast. Our machines are 2-20 times as powerful as most laser engravers.
Sorry, no we don’t offer that service.
Our tables have a large range of motion and can accommodate up to 17″ deep part.
Our large machine can hold a 50″ x 120″ sheet with a maximum cutting or engraving area of 48″ x 96″.
Our bed / table is 48″ x 96″ and can hold material 51″ x 120″.
Almost anything except Copper, Aluminum and some metals: Here is a list of some of the more common materials we blast, burn, carve, cut, engrave, etch and Mark:
ABS
Acrylic
Cardboard
Chipboard
Cold Rolled Steel
Ceramic
Concrete
Cork
Delrin
Fabric Cloth
Foam
Gasket
Galvanized Steel
Glass
Granite
Hot Rolled Steel
Leather
Marble
Mild Steel
MDF
Natural Stone
Paper
Plastic
Plywood
Polycarbonate
Polyethylene
Polyurethane
Rubber
Screen
Sheet Magnets
Shim Stock
Silicone
Stainless Steel
Steel
Stone
Tiles
Urethane
Veneer
Wood
No we can not cut copper, brass or bronze.
At this time we can’t cut Aluminum thicker than 1/32 thick and we can’t cut copper or brass.
Yes we can cut gaskets and seals.
Yes we can cut wood up to 1″ thick.
Yes, up to 3/4″ thick.
Yes we can cut acrylic up to 1.5″ thick and 1″ thick with a nice fire polished edge.
Yes we can.
Yes we can but not on the laser. We cut stone on a diamond saw and are limited to 24″ in one direction.
Yes, up to 1.5″ thick depending on the density?
Yes, up to 1″ thick.
Most types of foam we can cut up to 2″ but as the material gets thicker the edge kerf gets more beveled due to the beam getting out of focus.
We can etch glass, sand carve it, sand blast it but we can’t cut it.
Yes we can
Most plastics we cut unless they contain Vinyl or PVC (Polyvinylcloride). Sintra one example of a PVC plastic. These plastics create chloride gas when cut and are deadly.
Yes we can galvanized steel up to 11ga or 1/8″
Yes we can cut steel up to 7ga or 3/16″.
Yes we can cut stainless steel up to 13ga.
Yes we can laser cut hot rolled steel up to 7 ga or 3/16″ thick
Get in Touch
Office visits are by appointment only, please contact us if you would like to meet to discuss your project in person.